| Coupling part numbers
consist of four sections. To determine the correct numbers/letters
for each section of a specific coupling part number, please refer to
the charts on the following pages.
Example
* Refer to "Standard Bore
Diameters" section in chart |
1. Basic Model Number:
DSAC = Double start flexure, Aluminum and Integral Clamp
2. Outside Diameter Designator:
This
three-digit number represents the coupling size. Based on the
Performance Data at the center of the chart, select the Outside
Diameter Designator by moving left to the appropriate diameter.
3. Major Bore Designator:
The larger of
the two bores, its diameter is expressed in either 32nds of an inch
(-8 equals 1/4 inch) or in millimeters (6mm). Please review your
selection to determine if both bores can be made in the size
coupling you have selected in
2.
It is important that the larger bore be stated first.
4. Minor Bore Designator:
The smaller of the two bores, is
expressed the same as the Major Bore Designator. Either bore can be
inch or mm. |
We
manufacture single piece 
