| Coupling
part numbers consist of four sections. To determine the correct
numbers/letters for each section of a specific coupling part number,
please refer to the charts on the following pages.
Example
*Refer to "Standard Bore Diameters" section of
chart |
1. Basic Model Number:
MCAC =
Aluminum, Integral Clamp
MCA = Aluminum, Set Screw
MC7C = Stainless Steel, Integral Clamp
MC7 = Stainless Steel, Set Screw
2. Outside Diameter
Designator:
This three-digit number represents the coupling size. Based on the
Performance Data in the middle of the chart, select the Outside
Diameter Designator by moving left to the appropriate diameter.
3. Major
Bore Designator:
The larger of the two bores, its diameter is
expressed in either 32nds of an inch (-8 equals 1/4 inch) or in
millimeters (6mm). Please review your selection to determine if both
bores can be made in the size coupling you have selected in
2. It is
important that the larger bore be stated first.
4. Minor Bore Designator:
The smaller of the two bores, is
expressed the same as the Major Bore Designator. Either bore can be
inch or mm. |
We
manufacture single piece 
